2. Route the antenna cables through the routing guides on the chassis.
3. Peel the antenna modules off the chassis.
Installing the antenna modules
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the antenna modules and provides a visual representation of the installation
procedure.
Steps
1. Place the antenna modules into the slots on the chassis.
2. Replace the two screws (M3) that secure the antenna modules to the chassis.
3. Route the antenna cables through the routing guides on the chassis and thread the cables through the slot on the chassis.
Removing and installing components
27
To Next Page
Loading...
