4. Replace the two screws (M2x2) that secure the optical drive to the chassis.
5. Connect the optical-drive power cable to the connector on the optical drive.
6. Connect the optical-drive data cable to the connector on the optical drive.
Next steps
1. Install the left-side cover.
2. Install the front cover.
3. Follow the procedure in After working inside your computer.
Optical-drive bezel
Removing the optical-drive bezel
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the optical drive.
About this task
NOTE: These steps are only applicable for computers that are shipped with the optional optical drive.
The following image(s) indicate the location of the optical-drive bezel and provides a visual representation of the removal
procedure.
Steps
Pry and lift the optical-drive bezel from the optical drive.
42
Removing and installing components
To Next Page
Loading...
