4. Remove the two screws (M2x2) that secure the optical drive to the chassis.
5. Slide and lift the optical drive from its slot on the chassis.
6. Remove the optical drive bezel.
Installing the optical drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: When installing the optional optical drive, ensure that the front cover of your computer has the slot for it.
The following image(s) indicate the location of the optical drive and provides a visual representation of the installation
procedure.
Steps
1. Install the optical drive bezel.
2. Slide and replace the optical drive into its slot on the chassis.
3. Align the screw holes on the optical drive with the screw holes on the chassis.
Removing and installing components
41
To Next Page
Loading...
