About this task
The following image(s) indicate the location of the hard drive and provides a visual representation of the installation procedure.
Steps
1. Hold the hard drive into place on the chassis and align the screw holes on the hard drive with the screw holes on the chassis.
2. Connect the hard-drive power cable and hard-drive data cable to the hard drive.
3. Replace the four screws (6-32) that secure the hard drive to the chassis.
Next steps
1. Install the front cover.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Removing and installing components
39
To Next Page
Loading...
