Removing and Installing Parts 129
6
Replace and tighten the four screws to secure the hard drive.
7
Connect the power and data cables to the drive.
8
Connect the data cable to the system board.
9
Check all cables to be certain that they are properly connected and
firmly seated.
1 second hard drive
(optional)
2 serial ATA data cable 3 power cable
4 system board
connector
5 screw holes in the hard
drive bay (4)
6 screws (4)
2
4
3
1
6
5
book.book Page 129 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
