Removing and Installing Parts 131
4
Disconnect the power and data cables from the back of the floppy drive.
NOTE: If you have installed a PCI Express x16 card, this card may cover the
floppy-drive connectors. Remove this card before disconnecting the floppy-
drive cables
(see "Removing a PCI/PCI Express Card
" on page 119
)
5
Disconnect the data cable from the system board.
6
Remove the two screws securing the floppy drive.
7
Slide the floppy drive out through the front of the computer.
8
If you are not replacing the drive, reinstall the drive panel insert
(see "Replacing the CD/DVD Panel Insert" on page 144).
1 floppy drive 2 data cable 3 power cable
4 system board connector 5 screws (2)
2
4
3
1
5
book.book Page 131 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
