2. Lift the speaker cable and route the coin-cell battery cable under the speaker cable.
3. Connect the coin-cell battery cable to the I/O board.
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Memory module
Removing the memory module
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
The following image indicates the location of the memory modules and provides a visual representation of the removal
procedure.
1. Lift the flap to access the memory module.
2. Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the memory
module pops up.
3. Slide and remove the memory module from the memory-module slot.
Removing and installing components
19
To Next Page
Loading...
