1. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
2. Replace the screw (M2x3.5) that secures the power-adapter port to the palm-rest and keyboard assembly.
3. Connect the power-adapter port cable to the system board.
4. Close the right display-hinge.
5. Replace the three screws (M2.5x4.5) that secure the right display-hinge to the palm-rest and keyboard assembly.
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power-button board
Removing the power-button board
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the fan.
4. Remove the I/O board.
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
Removing and installing components
43
To Next Page
Loading...
