1. Disconnect the fan cable from the system board.
2. Release the fan cable by lifting the I/O-board cable.
3. Remove the two screws (M2x3.5) that secure the fan to the palm-rest and keyboard assembly.
4. Lift the fan off the palm-rest and keyboard assembly.
Installing the fan
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the fan and provides a visual representation of the installation procedure.
1. Using the alignment posts, place the fan on the palm-rest and keyboard assembly.
Removing and installing components
27
To Next Page
Loading...
