2. Replace the two screws (M2x3.5) that secure the system fan to the palm-rest and keyboard assembly.
3. Route the fan cable under the I/O-board cable.
4. Connect the fan cable to the system board.
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the M.2 2230 solid-state drive
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
1. Remove the screw (M2x3.5) that secure the solid-state drive thermal bracket to the palm-rest and keyboard assembly.
2. Lift the solid-state drive thermal bracket off the palm-rest and keyboard assembly.
3. Remove the screw (M2x3.5) that secures the solid-state drive to the solid-state drive bracket.
4. Slide and remove the solid-state drive from the solid-state drive slot.
28
Removing and installing components
To Next Page
Loading...
