1. Remove the two screws (M2x3.5) that secure the power-button bracket to the palm-rest and keyboard assembly.
2. Lift the power-button bracket off the palm-rest and keyboard assembly.
3. Peel the power-button board cable from the palm-rest and keyboard assembly.
4. Lift the power-button board, along with its cable, off the slot on the palm-rest and keyboard assembly.
Installing the power-button board
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the power-button board and provides a visual representation of the installation
procedure.
44
Removing and installing components
To Next Page
Loading...
