1. Align the screw holes on the keyboard with the screw holes on the palmrest.
2. Align the screw holes on the keyboard bracket with the screw holes on the keyboard.
3. Replace the 42 screws (M1.2x1.5) that secure the keyboard and the keyboard bracket to the palm-rest and keyboard
assembly.
4. Adhere the tape on the screw holes.
5. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
6. Route the coin-battery cable under the speaker cable.
1. Install the system board.
2. Install the power-button board.
3. Install the power-adapter port.
4. Install the display assembly.
5. Install the I/O board.
6. Install the fan.
7. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
8. Install the heat sink.
9. Install the wireless card .
10. Install the memory module.
11. Install the battery.
12. Install the base cover.
13. Follow the procedure in After working inside your computer.
Palmrest
Removing the palmrest
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the touchpad.
5. Remove the coin-cell battery.
6. Remove the speakers
7. Remove the memory module.
8. Remove the wireless card.
9. Remove the heat sink.
10. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
11. Remove the fan.
12. Remove the I/O board.
13. Remove the display assembly.
14. Remove the power-adapter port.
15. Remove the power-button board.
Removing and installing components
53
To Next Page
Loading...
