1. Place the display assembly on a dry, flat, and clean surface.
2. Slide the palm-rest and keyboard assembly at an angle, and place the palm-rest and keyboard assembly on the display
assembly.
3. Replace the three screws (M2.5x4.5) that secure the left-display hinge to the palm-rest and keyboard assembly.
4. Replace the three screws (M2.5x4.5) that secure the right-display hinge to the palm-rest and keyboard assembly.
5. Connect the display-cable connector to the system board.
6. Adhere the tape that secures the display cable to the system board.
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
The following image indicates the location of the power-adapter port and provides a visual representation of the removal
procedure.
Removing and installing components
41
To Next Page
Loading...
