1. Remove the three screws (M2x3.5) that secure the touchpad bracket to the palm-rest and keyboard assembly.
2. Lift the touchpad bracket off the palm-rest and keyboard assembly.
3. Open the latch, and disconnect the touchpad cable from the system board.
4. Peel the tape that secures the touchpad to the palm-rest and keyboard assembly.
5. Remove the five screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
6. Slide and lift the touchpad, along with the cable, off the palm-rest and keyboard assembly.
Installing the touchpad
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
36
Removing and installing components
To Next Page
Loading...
