48 Hard Drive
Replacing the Hard Drive
Procedure
1
Slide the hard drive into the hard-drive cage.
2
Align the screw holes on the hard-drive cage with the screw holes on
the hard drive.
3
Replace the screws that secure the hard-drive cage to the hard drive.
4
Place the hard-drive cage on the chassis and slide it toward the bottom of
your computer. Ensure that the tabs at the bottom of the hard-drive cage
slide into the slots on the chassis.
5
Route the power-supply cable through the routing guide on
the hard-drive cage.
6
Route the optical drive's power and data cable and the B-CAS card cable
through the routing guides on the hard-drive cage.
7
Route the hard-drive’s power and data cable through the routing guide on
the hard-drive cage.
8
Connect the power and data cable to the connector on the hard drive.
Postrequisites
1
Replace the VESA-mount bracket.
See "Replacing the VESA-Mount Bracket" on page 44.
2
Replace the back cover. See "Replacing the Back Cover" on page 24.
3
Replace the stand. See "Replacing the Stand" on page 21.
4
Follow the instructions in "After Working Inside Your Computer" on page 13.
OM_Book.book Page 48 Friday, March 30, 2012 1:21 PM
To Next Page
Loading...
