1 Disconnect the coin-cell battery cable from the system board.
2 Remove the coin-cell battery cable from the routing guide.
3 Peel the coin-cell battery o the palm-rest and keyboard assembly.
Installing the coin-cell battery
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation procedure.
1 Adhere the coin-cell battery to the slot on the palm-rest and keyboard assembly.
2 Route the coin-cell battery cable through the routing guide.
Removing and installing components
19
To Next Page
Loading...
