1 Align and place the palm-rest and keyboard assembly on the display assembly.
2 Using the alignment posts, close the display hinges.
3 Replace the two screws (M2.5x3.5) that secures the left display hinge to the I/O board and palm-rest and keyboard assembly.
4 Replace the screw (M2x4) that secures the right display hinge to the system board.
5 Connect the display cable on to the connector on the system board
6 Align and place the display-cable bracket on the display cable.
7 Replace the screw (M2x4) that secures the display-cable bracket to the system board.
1 Install the battery.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
I/O board
Removing and installing components
41
To Next Page
Loading...
