1 Connect the antenna cables to the WLAN card.
2 Align the notch on the WLAN card with the tab on the WLAN card slot and insert the WLAN card at an angle into the WLAN card slot.
3 Align and place the WLAN card bracket on the WLAN card.
4 Replace the screw (M2x2.5) to secure the WLAN card bracket to the WLAN card.
1 Install the battery.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
WWAN card
Removing the WWAN card
NOTE
: This procedure is only applicable for computers shipped with a WWAN conguration.
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
The following image indicates the location of WWAN card and provides a visual representation of the removal procedure.
Removing and installing components
31
To Next Page
Loading...
