The following image indicates the location of camera and provides a visual representation of the removal procedure.
1 Peel the tape that secures the camera to the display back-cover
2 Using a plastic scribe, pry the camera from the alignment post on the display back-cover.
3 Turn over the camera and disconnect the camera cable o the camera.
4 Peel the tape o the camera and lift the camera o the display back-cover.
Installing the camera
NOTE
: This procedure is not applicable to computers shipped with a WWAN conguration.
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of camera and provides a visual representation of the installation procedure.
Removing and installing components
59
To Next Page
Loading...
