Steps
Adhere the tape to secure the eDP cable to the display back cover.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display assembly.
5. Install the 3-cell battery or 4-cell battery.
6. Install the base cover.
7. Follow the procedure in after working inside your computer.
Camera
Removing the camera
Prerequisites
NOTE: The camera removal procedure is applicable only for Latitude 5330 laptop and not for the 2-in-1 configuration.
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or 4-cell battery.
4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display hinges.
7. Remove the display panel.
About this task
The following images indicate the location of the camera and provide a visual representation of the removal procedure.
Steps
1. Peel the conductive tape that secures the camera cable in place.
2. Lift the latch and disconnect the camera cable from the connector on the camera module.
100
Removing and installing components
To Next Page
Loading...
