Steps
Place the display back-cover on a flat surface and perform the following steps to install the display back cover.
Next steps
1. Install the eDP cable.
2. Install the camera.
3. Install the display panel.
4. Install the display hinges.
5. Install the display bezel.
6. Install the display assembly.
7. Install the 3-cell battery or 4-cell battery.
8. Install the base cover.
9. Follow the procedure in after working inside your computer.
Sensor board
Removing the sensor board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or 4-cell battery.
4. Remove the display assembly.
Removing and installing components
105
To Next Page
Loading...
