Installing the GPS module
1 Align and place the GPS module on the system board and tighten the two 'M2.5*5' screws on GPS module [2].
2 Connect the GPS FPC(system board side rst) [3] and secure it using a piece of tape [4].
3 Install the RF bracket [1] on the system board and secure it using the single 'M2.5*5' screw [2].
4 Route the aux cables for WLAN and WWAN cards through the RF bracket [3].
5 Connect the antennae cable [4] on GPS module and route the main antennae cables [5] through the RF bracket.
Removing and installing components
123
To Next Page
Loading...
