Smart Card
Removing the Smart Card Reader
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Batteries
b Bottom chassis cover
c PCIe heatsink assembly
d Battery bay
3 Remove the tape from the smart card reader connector[1] and disconnect it [2] from the USH board.
4 Remove the tape from the ngerprint reader connector [3] and disconnect it from the USH board [4].
5 Remove the two 'M2*3' screws [1] securing the USH board to the bottom base and turn it up side down [2].
Removing and installing components
161
To Next Page
Loading...
