4 Install the:
a Heatsink
b PCIe Heatsink assembly
c Docking port assembly
d WWAN card
e WLAN card
f Bottom chassis cover
g Batteries
5 Follow the procedure in After working inside your computer.
Display assembly
Removing the Display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Batteries
b Bottom chassis cover
c PCIe heatsink assembly
d Docking port assembly
e WLAN card
f WWAN card
g GPS module
h Heatsink assembly
i Hinge covers
3 Remove the two 'M2*3' screws [1] on the EDP bracket, and turn it up side down [2].
4 Pull and disconnect the EDP cable from the system board [3] and remove the two 'M2*3' screws [4] securing the hinges to base
assembly [5].
Removing and installing components
141
To Next Page
Loading...
