Dell Latitude 5424 Rugged - Installing the Camera

3 Peel o the reective tape[1] on camera module and the insulation tape securing the EDP cable[2] to camera module.
4 Disconnect the EDP cable from the camera module [3] and remove the two 'M2*3' screws [4].
5 Lift the camera module away from the back cover [5] to remove it from the computer.
CAUTION: Do not touch the Camera Lens fused to the LCD with bezel assembly.
Installing the Camera
1 Install the camera module [1] on the back cover and install the two 'M2*3'. screws [2]
2 Connect the EDP cable to the camera module [3], stick a piece of insulation tape [4] on the EDP connectors.
3 Secure the camera module on the back cover using a piece of reective tape [5].
152
Removing and installing components