3 Loosen the 12 'M2.5' screws from the back cover.
4 Remove the four 'M2.5' epoxy screws securing the bezel to the back cover [1] and pry at bottom edge to separate the two
subassemblies [2].
5 Peel o the tape on the LCD connections [1] and open the connector [2] to disconnect the EDP cable [3] from the LCD.
6 Peel o the reective tape [4] on the LCD panel and the touch connector [5] and disconnect the cable from the board [6].
146
Removing and installing components
To Next Page
Loading...
