Dell Networking N3024 User Manual

5 Expansion Modules for Dell Networking Switches
Executive Summary
Dell offers several blade and rack-mounted switches that can be upgraded by installing expansion
modules. Using Dell’s FlexIO technology, these modules can be used to increase access ports,
augment upstream bandwidth, extend media forms (10GBase-T, SFP+, QSFP+, CX4, XFP), or add
stacking capabilities.
When possible, Dell allows for a module to be used in multiple devices. You can freely move a module
from one device to another device when supported.
This document identifies each Dell Networking switch and its corresponding set of expansion
modules. In this document, Blade Switches and Corresponding Modules lists and describes modules
for corresponding blade switches that install into a Dell M1000e blade chassis. Rack Switches and
Corresponding Modules lists and describes modules for corresponding rack-mounted switches.

Dell Networking N3024 Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
MAC Address Table Size	16, 000 entries
Power Supply	Internal power supply
Rack Units	1U
Operating Temperature	0 °C to 45 °C
Ports	24 x 10/100/1000
Routing Protocol	OSPF, RIP
Remote Management Protocol	SNMP 1
Features	VLAN support, QoS, IGMP snooping, port mirroring, DHCP snooping, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3x, IEEE 802.1w, IEEE 802.1x, IEEE 802.1s, IEEE 802.1ab
Jumbo Frame Support	Yes
Storage Temperature	-40 °C to 65 °C
Operating Humidity	10 to 90% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)