Dell Networking N3024 User Manual

7 Expansion Modules for Dell Networking Switches
2 SFP+ Modules and Optic Requirements
When selecting optic transceivers or cables for SFP+ modules described in this document, it is
important to understand that while some SFP+ ports accepts both 1G and 10G, not all do. As seen in
the table below, most fixed port SFP+ ports on Dell Networking switches allow both 10G and 1G SFP+
optics; however, the expansion module ports often allow only 10G optics.
Table 1
Port Type /Switch
SFP+ expansion module
ports
SFP+ fixed ports
M6220
1. 10G only
2. n/a
3. M8024
4. 10G only
5. n/a
6. M8024-k
7. 10G only
8. 1G and 10G
9. Force10 MXL
10. 1G and 10G
11. n/a
12. 62XX
13. 10G only
14. n/a
15. 70XX
16. 1G and 10G
17. n/a
18. 81XX
19. 1G and 10G
20. 1G and 10G
21. N30XX
22. 1G and 10G
23. 1G and 10G
24. N40XX
25. 1G and 10G
26. 1G and 10G
Dell Networking switches that do not accept expansion modules are not listed in the table above, even
though they may contain SFP+ fixed ports (e.g. M6348 and 8000 series).

Dell Networking N3024 Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
MAC Address Table Size	16, 000 entries
Power Supply	Internal power supply
Rack Units	1U
Operating Temperature	0 °C to 45 °C
Ports	24 x 10/100/1000
Routing Protocol	OSPF, RIP
Remote Management Protocol	SNMP 1
Features	VLAN support, QoS, IGMP snooping, port mirroring, DHCP snooping, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3x, IEEE 802.1w, IEEE 802.1x, IEEE 802.1s, IEEE 802.1ab
Jumbo Frame Support	Yes
Storage Temperature	-40 °C to 65 °C
Operating Humidity	10 to 90% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)