19 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
Click System > Stack Management > Stack Port Summary to bring up the next page used to select the
ports for stacking. For this example ports Te1/0/7 and Te1/0/8 are used.
Selecting the Edit check box activates the drop-down menu in the Configured Stack-mode column. Use
this menu to change port modes from Ethernet to Stack.
Click Apply. This will set the Configured Stack Mode to
Stack
, but the Running Stack Mode remains
Ethernet
until the switch is reloaded as instructed below.
To Next Page
Loading...
