Steps
1. Align and place the smart card reader on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x2) that secure the smart card reader to the palm-rest and keyboard assembly.
3. Adhere the smart card reader cable on the palm-rest and keyboard assembly.
4. Connect the smart card reader flexible flat cable to the respective connectors on the clickpad.
5. Connect the clickpad flexible flat cable, keyboard backlight flexible printed circuit, and keyboard flexible printed circuit to the
connectors on the clickpad.
Next steps
1. Install the 2-cell battery or the3-cell battery, whichever is applicable.
2. Install the speakers.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
46
Removing and installing components
To Next Page
Loading...
