Dell PowerConnect W-Airwave - Define AWMS as Trap Host Using Dell Powerconnect Arubaos CLI; Dell Powerconnect Arubaos Traps Utilized by AWMS; Auth Traps; IDS Traps

Dell PowerConnect W AirWave 7.2 | Best Practices Guide AWMS and Dell PowerConnect W Integration Strategies | 23
Define AWMS as Trap Host using Dell PowerConnect ArubaOS CLI
To ensure the AWMS server is defined a trap host, SSH into each controller (Master and Local), enter “enable”
mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # snmp-server host <AWMS IP ADDR> version 2c <SNMP
COMMUNITY STRING OF CONTROLLER>
(Controller-Name) (config) # snmp-server trap source <CONTROLLER'S IP>
(Controller-Name) (config) # write mem
Dell PowerConnect ArubaOS Traps Utilized by AWMS
The following are Auth, IDS, and ARM traps utilized by AWMS:
 “Auth Traps” on page23
 “IDS Traps” on page23
 “ARM Traps” on page24
Auth Traps
 wlsxNUserAuthenticationFailed
 wlsxNAuthServerReqTimedOut
IDS Traps
 wlsxwlsxSignatureMatchAP
 wlsxSignatureMatchSta
 wlsxSignAPNetstumbler
 wlsxSignStaNetstumbler
 wlsxSignAPAsleap
 wlsxSignStaAsleap
 wlsxSignAPAirjack
 wlsxSignStaAirjack
 wlsxSignAPNullProbeResp
 wlsxSignStaNullProbeResp
 wlsxSignAPDeauthBcast
 wlsxSignStaDeauthBcastwlsxChannelFrameErrorRateExceeded
 wlsxChannelFrameFragmentationRateExceeded
 wlsxChannelFrameRetryRateExceeded
 wlsxNIpSpoofingDetected
 wlsxStaImpersonation
 wlsxReservedChannelViolation
NOTE: Ensure the SNMP community matches what was configured in Chapter 2, “CPU, BIOS, Operating Systems, and Storage” on
page7.
CAUTION: Do not configure the SNMP version to v3 because AWMS does not support SNMPv3 traps/informs.