Dell PowerConnect W-Airwave - Appendix A Dell Powerconnect Arubaos & AWMS Commands; Enable Channel Utilization Events (Local and Master Controllers); Enable Stats with the CLI (Local Controller in Master Local Environment); Offload WMS Utilizing Arubaos CLI and AWMS CLI (SNMP Walk)

Dell PowerConnect W AirWave 7.2 | Best Practices Guide Dell PowerConnect ArubaOS & AWMS Commands | 35
Appendix A
Dell PowerConnect ArubaOS & AWMS
Commands
Enable Channel Utilization Events (Local and Master Controllers)
SSH into the controller, and enter “enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mgmt-server type amp primary-server <AMP IP>
(Controller-Name) (config) # write mem
Enable Stats With the CLI (Local Controller in Master Local Environment)
SSH into the controller, and enter “enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # wms general collect-stats enable
(Controller-Name) (config) # write mem
Offload WMS Utilizing ArubaOS CLI and AWMS CLI (SNMP Walk)
Dell PowerConnect ArubaOS CLI
SSH into all controllers (local and master), and enter “enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
CAUTION: Enabling these commands on Dell PowerConnect ArubaOS versions prior to 6.1 can result in performance issues on
the controller.
NOTE: Do not use these commands if using the AWMS GUI.
CAUTION: Enabling these commands on Dell PowerConnect ArubaOS versions prior to 6.1 can result in performance issues on
the controller.
NOTE: Do not use these commands if using AWMS GUI.