Dell PowerConnect W-Airwave - Prerequisites for Integrating Dell Powerconnect W Infrastructure; Feature Implementation Schedule

6 |Overview Dell PowerConnect W AirWave 7.2 | Best Practices Guide
Prerequisites for Integrating Dell PowerConnect W Infrastructure
You will need the following information to monitor and manage your Dell infrastructure:
 SNMP community string (monitoring & discovery)
 Telnet/SSH credentials (configuration only)
 “enable” password (configuration only)
 SNMPv3 credentials are required for WMS Offload.
 Username
 Auth password
 Privacy password
 Auth protocol
Feature Implementation Schedule
The following table describes the feature implementation schedule for AWMS:
NOTE: Without proper Telnet/SSH credentials AWMS will not be able to acquire license and serial information from controllers.
Table 3 Dell PowerConnect W Feature Implementation Schedule for AWMS
Feature AWMS Implementation
Ability filter User Session by Dell PowerConnect ArubaOS roles 7.0
Dell PowerConnect ArubaOS 5.0 support 7.0
RAP white list management for RN 3.1 7.0
Added support for rogue containment 7.0
Added support for configuring controller specific overrides 7.0
Client dot11counter status 7.0
Added support for AP-92 and AP-93 7.1
Ability to use controller WIPS classification within RAPIDS 7.1
Use controller classification/confidence level within a RAPIDS rule 7.1
Dell PowerConnect ArubaOS provides Ad-Hoc rogues and encryption type 7.1
Channel Utilization 7.1
AP dot11counter statistics 7.1
Support for SNMPv3 informs 7.1
Track BW on wired users connected to RAPs 7.1
Ability to configure SNMP local configuration 7.1
Ability to track ARM power and channel changes 7.2
Ability to track Noise Floor 7.2
Ability to track Interfering Devices 7.2
Ability to store and display ARM logs 7.2