Dell PowerConnect W-Airwave - Defining General AWMS Server Settings

Dell PowerConnect W AirWave 7.2 | Best Practices Guide Dell PowerConnect ArubaOS & AWMS Commands | 37
Ensuring Master Controller Pushes Config to Local Controllers Utilizing
ArubaOS CLI
(Controller-Name) (config) # cfgm mms config disable
(Controller-Name) (config) # write mem
Disable Debugging Utilizing ArubaOS CLI
If you are experiencing performance issues on the Master Controller, ensure that debugging is disabled. It should
be disabled by default. Debugging coupled with gathering the enhanced statistics can put a strain on the
controllers CPU, so it is highly recommended to disable debugging.
To disable debugging, SSH into the controller, enter “enable” mode, and issue the following commands:
(Controller-Name) # show running-config | include logging level debugging
If there is output, then use the following commands to remove the debugging:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # no logging level debugging <module from above>
(Controller-Name) (config) # write mem
Restart WMS on Local Controllers Utilizing ArubaOS CLI
To ensure local controllers are populating rogue information properly, SSH into each local controller, enter
“enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # process restart wms
Configure ArubaOS CLI when not Offloading WMS to AWMS (AOS 6.0 &
GT)
To ensure proper event correlation for IDS events when WMS if not offloaded to AWMS, SSH into each
controller (Master and Local), enter “enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # ids management-profile
(Controller-Name) (config) # ids general-profile <name>
(Controller-Name) (config) # ids-events logs-and-traps
NOTE: Do not use these commands if using AWMS GUI.
NOTE: This command ensures configuration changes made on the master controller will propagate to all local controllers.
NOTE: You will need to wait until the next Rogue Poll Period to execute a Poll Now for each local controller to see rogue devices
begin to appear in AWMS after executing restart wms in Dell PowerConnect ArubaOS.