Dell PowerEdge 2970 - Solving LCD Status Message Problems

About Your System 27
Solving Problems Described by LCD Status Messages
The code and text on the LCD can often specify a very precise fault condition that is easily corrected. For
example, if the code
E1418 CPU_1_Presence appears, you know that a microprocessor is not installed
in socket 1.
In contrast, you might be able to determine the problem if multiple related errors occur. For example, if
you receive a series of messages indicating multiple voltage faults, you might determine that the problem
is a failing power supply.
E2112 Mem Spare DIMM # The system BIOS has spared the
memory because it has
determined that the memory had
too many errors. "# & #"
represents the DIMM pair
implicated by the BIOS.
See "Troubleshooting System
Memory" on page 124.
I1910 Intrusion System cover has been removed. Information only.
I1911 >3 ERRs Chk Log LCD overflow message.
A maximum of three error
messages can display sequentially
on the LCD. The fourth message
displays as the standard overflow
message.
Check the SEL for details on the
events.
I1912 SEL Full System Event Log is full of
events, and is unable to log any
more events.
Clear the log by deleting event
entries.
I1915 Video Off
(LCD lights with a blue
or amber background.)
The video has been turned off by
the RAC remote user.
Information only.
I1916 Video Off in ##
(LCD lights with a blue
or amber background.)
The video will be turned off in xx
seconds by the RAC remote user.
Information only.
W1228 ROMB Batt < 24hr Warns predictively that the RAID
battery has less than 24 hours of
charge left.
Replace RAID battery. See "RAID
Battery" on page 69.
NOTE: For the full name of an abbreviation or acronym used in this table, see the "Glossary" on page 175.
Table 1-6. LCD Status Messages (continued)
Code Text Causes Corrective Actions