6 Repeat the procedure for the remaining two screws.
Next steps
1 Install the cooling shroud.
2 Follow the procedure listed in After working inside your system.
3 While booting, press F2 to enter System Setup and check that the processor information matches the new system conguration.
4 Run the system diagnostics to verify that the new processor operates correctly.
Related links
Removing the cooling shroud
Installing the processor
Installing the cooling shroud
Power supply unit
Your system supports a 250 W AC non-redundant power supply unit (PSU).
Removing a cabled power supply unit
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Disconnect the power cables from the power supply unit (PSU) to the system board, hard drives, and optical drive.
Step
Remove the screw securing the PSU to the chassis, slide the PSU toward the front of the chassis and lift it out of the chassis.
112
Installing and removing system components
To Next Page
Loading...
