Dell PowerEdge R730 - Page 95

Steps
1. Loosen the screws that secure the integrated storage controller cable to the integrated storage-
controller card connector on the system board.
2. Lift the integrated storage controller cable out.
3. Lift one end of the card and angle it to disengage the card from the integrated storage-controller
card holder on system board.
4. Lift the card out of the chassis.
Figure 39. Removing and installing the integrated storage controller card
1. integrated storage controller cable 2. integrated storage controller card
3. integrated storage-controller card
connector on the system board
4. integrated storage controller card
holder
Next steps
1. Replace the expansion-card riser 1.
2. Replace the cooling shroud.
3. Follow the procedure listed in After working inside your system.
95