Dell PowerEdge R730 - Page 97

Riser PCIe slot Processor
connection
Height Length Link width Slot width
1 3 Processor 2 Low Profile Half Length x8 x16
2 4 Processor 2 Full Height Full Length x16 x16
2 5 Processor 1 Full Height Full Length x8 x16
3 (default) 6 Processor 1 Full Height Full Length x8 x16
3 (alternate) 6 Processor 1 Full Height Full Length x16 x16
3 (default) 7 Processor 1 Full Height Full Length x8 x16
NOTE: To use PCIe slots 1 through 4 on the riser, both the processors must be installed.
NOTE: The expansion-card slots are not hot-swappable.
The following table provides guidelines for installing expansion cards to ensure proper cooling and
mechanical fit. The expansion cards with the highest priority should be installed first using the slot priority
indicated. All other expansion cards should be installed in card priority and slot priority order.
Table 4. Expansion card installation order
Card
priority
Card type Slot priority Max allowed
PowerEdge
R730
PowerEdge
R730xd
PowerEdge
R730
PowerEdge
R730xd
1 PCIe Bridge not supported 4 0 1
2 GPU (double wide) 6, 4 not supported 2 0
GPU (single wide) 6, 4, 7, 5 not supported 4 0
3 RAID H730P (low profile) not supported 3, 2 0 1
4 RAID H830 7, 6, 4, 5 6, 4, 5 2 2
RAID H830 (low profile) 3, 2 3, 2 2 2
5 40 Gb NICs (full height) 5, 7, 4, 6 4, 6, 5 4 3
40 Gb NICs (low profile) 3, 2, 1 3, 2, 1 3 3
6 FC16 HBA (full height) 5, 7, 4, 6 4, 6, 5 4 3
FC16 HBA (low profile) 2, 3, 1 2, 3, 1 3 3
7 10 Gb NICs (full height) 5, 7, 4, 6 4, 6, 5 4 3
10 Gb NICs (low profile) 2, 3, 1 2, 3, 1 3 3
8 FC8 HBA (full height) 5, 7, 4, 6 4, 6, 5 4 3
FC8 HBA (low profile) 2, 3, 1 2, 3, 1 3 3
9 1 Gb NICs (full height) 5, 7, 4, 6 4, 6, 5 4 3
1 Gb NICs (low profile) 2, 3, 1 2, 3, 1 3 3
10 12 Gb SAS (low profile) 3, 2, 1 3, 2, 1 3 3
97