Installing System Components 125
4
Insert the USB memory key into the USB connector. See Figure 3-21.
5
Close the system. See "Closing the System" on page 86.
6
Place the system upright on a flat surface.
7
Reattach any peripherals and connect the system to an electrical outlet.
8
Turn on the system and attached peripherals.
9
Enter the System Setup program and verify that the USB key
has been detected by the system. See "Entering the System Setup
Program" on page 58.
Figure 3-21. Removing or Installing a USB Memory Key
1 USB memory key 2 USB memory key connector
book.book Page 125 Wednesday, August 19, 2009 4:40 PM
To Next Page
Loading...
