Installing System Components 131
Figure 3-24. Replacing the System Battery
4
Remove the PCIe expansion card from slot 1. See "Removing an
Expansion Card" on page 118.
5
Locate the battery socket. See "System Board Connectors" on page 170.
CAUTION: To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
6
Support the battery connector by pressing down firmly on the positive side
of the connector.
7
Press the battery toward the positive side of the connector and lift it up
out of the securing tabs at the negative side of the connector.
8
Install the new battery by pressing down firmly on the positive side
of the connector.
9
Hold the battery with the "+" facing up, and slide it under the securing
tabs at the positive side of the connector.
10
Press the battery straight down into the connector until it snaps into place.
11
Install the expansion card. See "Installing an Expansion Card" on page 115.
12
Install the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer" on page 87.
1 positive side of battery connector 2 system battery
3 negative side of battery connector
book.book Page 131 Wednesday, August 19, 2009 4:40 PM
To Next Page
Loading...
