Dell Precision 3580 - Sensor Board; Removing the Sensor Board

Steps
1. Connect the display cable to the connector on the camera.
2. Adhere the display cable to the display back cover.
3. Adhere the tape that secures the display cable to the display back cover.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WLAN card.
5. Install the 4G WWAN card or 5G WWAN card, as applicable.
6. Install the base cover.
7. Install the SIM card.
8. Follow the procedure in After working inside your computer.
Sensor board
Removing the sensor board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
4. Remove the 4G WWAN card or 5G WWAN card, as applicable.
5. Remove the WLAN card.
6. Remove the display assembly.
118
Removing and installing Field Replaceable Units (FRUs)