Next steps
1. Install the assembly-inner frame.
2. Install the battery.
3. Install the heat sink (discrete GPU) or heat sink (integrated GPU), as applicable.
4. Install the M.2 2230 solid-state drive in Slot 2, if applicable.
5. Install the M.2 2230 or M.2 2280 solid-state drive in Slot 1, as applicable.
6. Install the memory modules.
7. Install the WLAN card.
8. Install the 4G WWAN card or 5G WWAN card, as applicable.
9. Install the base cover.
10. Install the SIM card.
11. Follow the procedure in After working inside your computer.
Power button
Removing the power button
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the 4G WWAN card or 5G WWAN card, as applicable.
6. Remove the WLAN card.
7. Remove the memory modules.
8. Remove the M.2 2230 or M.2 2280 solid-state drive from Slot 1, as applicable.
9. Remove the M.2 2230 solid-state drive from Slot 2, if applicable.
10. Remove the heat sink (discrete GPU) or heat sink (integrated GPU), as applicable.
11. Remove the assembly-inner frame.
12. Remove the system board.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
90
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
