Installing the display bezel
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display bezel and provide a visual representation of the installation procedure.
Figure 75. Installing the display bezel
Steps
1. Align and place the display bezel on the display assembly.
2. Gently snap the display bezel into place.
Next steps
1. Install the display assembly.
2. Install the wireless card.
3. Install the 4G WWAN card or 5G WWAN card, as applicable.
4. Install the base cover.
5. Install the SIM card.
6. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
111
To Next Page
Loading...
