Figure 40. Routing the cables
Steps
1. Align the screw holes on the assembly-inner frame with the screw holes on the system board and the palm-rest assembly.
2. Replace the twelve screws (M2x3) that secure the assembly-inner frame to the palm-rest assembly.
3. Connect the speaker cable to the system board.
4. Route the speaker cables through the routing guides on the palm-rest assembly.
5. Route the antenna cables through the routing guides on the palm-rest assembly.
Next steps
1. Install the wireless card.
2. Install the 4G WWAN card or 5G WWAN card, as applicable.
3. Install the battery.
4. Install the base cover.
5. Install the SIM card.
6. Follow the procedure in After working inside your computer.
Touchpad
Removing the touchpad
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
4. Remove the battery.
Removing and installing Field Replaceable Units (FRUs)
79
To Next Page
Loading...
