2. Remove the SIM card.
3. Remove the base cover.
4. Remove the assembly-inner frame.
About this task
The following images indicate the location of the speakers and provide a visual representation of the removal procedure.
Figure 43. Removing the speakers
Steps
1. Disconnect the speaker cable from the speaker cable connector (SPK1) on the system board.
2. Remove the speaker cables from the routing guides on the palm-rest assembly.
3. Lift the right and left speakers, along with its cable, off the palm-rest assembly.
Installing the speakers
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the speakers and provide a visual representation of the installation procedure.
82
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
