Figure 44. Installing the speakers
Steps
1. Using the alignment posts, place the left and right speakers into their slots on the palm-rest assembly.
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Connect the speaker cable to the speaker cable connector (SPK1) on the system board.
NOTE:
Ensure that the rubber grommets are seated into the slot and installed on the speakers properly.
Figure 45. Rubber grommets
Next steps
1. Install the assembly-inner frame.
2. Install the base cover.
3. Install the SIM card.
4. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
83
To Next Page
Loading...
