7. Remove the battery cable away from the battery.
Installing the battery
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the battery and provide a visual representation of the installation procedure.
Figure 36. Installing the battery
Steps
1. Align and route the battery cable through the routing guides on the battery.
2. Adhere the tape that secures the battery cable to the battery.
3. Connect the battery cable to the connector on the battery.
4. Flip the battery.
74
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
