8. Remove the M.2 2230 SSD from slot 2, if applicable.
9. Remove the heat sink (discrete GPU) or heat sink (integrated GPU), as applicable.
10. Remove the battery.
11. Remove the assembly-inner frame.
About this task
The following images indicate the system board connectors.
Figure 52. System board connectors
1.
WWAN-card connector (WWAN1) 2. Wireless-card connector (WLAN1)
3. Sensor board-cable connector 4. Memory modules (DIMM1 and DIMM2)
5. Display-cable connector (LCD1) 6. System-fan connector (FAN1)
7. Solid-state drive Slot 1 (SSD1) 8. Touchpad-cable connector (TPAD1)
9. Battery-cable connector (BATT1) 10. Solid-state drive Slot 2 (SSD2)
11. USH-cable connector 12. Coin-cell battery cable connector (RTC1)
13. Speaker-cable connector (SPK1)
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
90
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
