Dell Precision 7920 Tower - Page 104

Option Description
7920 Tower
• SATA–0
• SATA–1
• SATA–2
• SATA–3
• SATA–4
• SATA–5
• SATA–6
• SATA–7
• SATA–8
Default Setting: All drives are enabled.
NOTE: If the hard drives are connected to a RAID
controller card, the hard drives will display {none} in all
the fields. The hard drives can be seen in the RAID
controller card BIOS.
PCIe Drives
Allows the enabling of Front PCIe attached Ports.
• MiniSAS PCIe SSD-0
• MiniSAS PCIE SSD-1
• MiniSAS PCIe SSD-2
• MiniSAS PCIE SSD-3
Default Setting: All drives are enabled.
SMART Reporting This field controls if the hard drive errors for the integrated drives
are reported during system startup. This technology is part of the
SMART (Self Monitoring Analysis and Reporting Technology)
specification.
• Enable SMART Reporting - This option is disabled by default.
USB Configuration Allows you to enable or disable the internal USB configuration. The
options are:
• Enable Boot Support
• Enable Front USB Ports
• Enable internal USB ports
• Enable rear USB Ports
HDD Fans Allows you to control the HDD fans.
Default Setting: depends on the system configuration
Audio Allows you enable or disable the audio feature.
• Enable Audio (Default)
Memory Map IO above 4GB Allows you enable or disable Memory Map IO above 4GB.
• Memory Map IO above 4GB - This option is disabled by
default.
Thunderbolt Allows you to enable or disable Thunderbolt device support
capability.
• Enabled
• Disabled (Default)
Miscellaneous devices Allows you to enable or disable various on board devices.
• Enable Secure Digital (SD) Card (Default On)
• Secure Digital (SD) Card Read Only Mode
• Secure Digital (SD) Card Boot
104 System Setup