Dell Precision 7920 Tower - System configuration

Option Description
UEFI Boot Path Security
Allows you to control whether the system prompts the user to enter
the Admin password when booting to a UEFI boot path.
Click one of the following options:
• Always, Except Internal HDD—Default
• Always
• Never
System configuration
Table 6. System Configuration
Option Description
Integrated NIC Allows you to configure the integrated network controller. The
options are:
• Enable UEFI Network Stack
• Disabled
NOTE: You can use the Disabled option, only if Active
Management Technology (AMT) option is disabled.
•
Enabled
• Enabled w/PXE (Default)
Integrated NIC 2 Allows you to configure the integrated network controller. The
options are:
• Enabled (Default)
• Enabled w/PXE
NOTE: This feature is supported only on Tower 7920.
UEFI Network Stack
Allows pre-OS and early OS networking features to use any
enabled NICs.
• Enabled UEFI Network Stack
This option is set by default.
Serial Port Identifies and defines the serial port settings. You can set the serial
port to:
• Disabled
• COM1 (Default)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources
even if the setting is disabled.
SATA Operation
7920 Tower Allows you to configure the internal SATA hard-drive controller.
The options are:
• Disabled
• AHCI
• RAID-On (Default)
NOTE: SATA is configured to support RAID mode.
Drives
System Setup 103